DFW Connector Design/Build Project in Dallas, Denton and Tarrant Counties, Texas

IEA provided various design services for this $1.0 Billon design/build project. These services included: structural design, drainage, utility relocation designs, 3D modeling, toll integration, and life cycle cost analyzes.

Life Cycle Cost Analyzes:
IEA staff performed extensive Life Cycle Cost Analyzes (LCCA) for the capital and routine maintenance assets. Evaluation included analyzing initial costs and discounted future costs, such as maintenance, user, reconstruction, rehabilitation, restoring, and resurfacing costs, over the life of 50 years. IEA staff utilized industry standard LCCA software and spreadsheets to determine the best value. The LCCA process also included interviews with personnel from design, construction and maintenance teams.

Toll Integration:
During the proposal phase, IEA prepared site adaptation plans for the tolling infrastructure of managed lanes. Tolling sites include gantries, barriers, foundations, equipment cabinets, buried conduits, backup power, signage, and maintenance access.

IEA provided project wide drainage design for the DFW Connector. The limits of the drainage design include SH 114 from Kimball Avenue to Main Street, SH 121 from Hall Johnson to SH 114 merge, SH 26 from Kimball Avenue to the east of Baylor Pkwy, SH 360 from south of Stone Myers to SH 121, FM 1709 from west of Gateway Drive to SH 114. IEA’s responsibilities included research and development of project specific drainage criteria and standards, establishment of existing conditions thru site visits and record document research, setup Geopak drainage software database specific to project standards and drainage criteria, designed drainage details necessary for project needs, coordinated drainage elements with TxDOT, area FEMA flood plain managers, and other agencies or project partners, coordinated design with all other disciplines (structures, roadway, geotechnical, etc.), and wrote the hydraulic report for the DFW Connector and other reports necessary for permitting.

The drainage design included 7 stream crossings with bridge class culverts, 5 detention ponds, closed and open drainage systems. The schematic design recommended large detention ponds outside the proposed ROW. IEA’s innovative drainage design eliminated the need to purchase ROW beyond the proposed ROW lines.

Hydrographs and peak flows were calculated using HEC-HMS (v3.3) and Geopak drainage, HEC-RAS (v4.1.0), and HY-8 were used for hydraulic analyzes.  Detention routing calculations were completed using HEC-HMS. 







Utility Adjustment:
IEA provided utility coordination and wet and dry utility design services for utility relocations. Utility relocations included communications, water, sewer, and cable lines.

IEA was part of the Structural Task Force for this project. IEA assisted in developing the bridge design directives and General Notes Sheet in conformance with TxDOT and CDA design guidelines for the project. IEA’s expertise in TxDOT bridge design was used to review the calculations prepared by the bridge design team. A total of 40 bridges, including 14 Direct Connectors were designed for the project. The majority of the bridges were part of four multi-level interchanges along the SH121/SH114 corridor. The review of all plans was performed at each submittal, checking for any issues with the calculations and consistency among the designers where required.

3D Modeling:
IEA performed 3D modeling for this project. The 3D model provided the basis for construction. The contractors used this 3D model for project layout/staking, scheduling and allocating resources required to build the DFW connector.







Construction Management:
IEA was involved in construction management for this project. IEA provided construction inspections and commissioning for illumination systems, fiber optic systems, CCTV cameras, and toll gantries.